Ground stress of rf coaxial cable components over output power is only tested for common component faults or after faults. This is often the case in telecommunications networks and aerospace engineering/defense applications where high power applications and exposures are necessary to consider the performance requirements of such applications. High-frequency and microwave heating power levels are high enough to destroy components in the signal path,
Rf coaxial connector is mainly due to big station was developed, which is suitable for 60 s, at the beginning of the most appropriate and no great change and progress, but, because of the need, have to upgrade and research and development, with the development of millimeter wave, in the use of the increase of frequency and the miniaturization of military, is to meet the requirements of the use of appropriate. MMW RF coaxial connectors have also received much attention and development, in the beginning of the development of suitable applications of technology through the driving force, to generate and amplify signals of active devices and transmission of passive devices as a regulator. The passive devices for transmitting millimeter-wave signals mainly include millimeter-wave transmission lines, connectors as part of the transmission lines and other millimeter-wave components. Millimeter wave transmission lines are mainly waveguide, semi-hard coaxial cable, soft coaxial cable, microstrip line and millimeter wave coaxial connector as a part of the transmission line.
Rf coaxial connectors are widely used in communication systems. The reliability of the connectors is directly related to the communication quality of the whole communication system. With the increase of transmission signal rate of communication system, the quality of coaxial connector in communication system increases, and the quality of connector is directly affected by the quality of high-speed signal communication. With the rapid development of modern science and technology, all kinds of electronic devices are more and more widely used, which puts forward higher and higher requirements for the reliability and stability of all electronic devices and systems. One of the most common components of failure in various electronic devices may be electrical contacts. According to the analysis, an important reason for the increase of bit error rate is the poor quality of coaxial connectors on the digital distribution frame in the system, coupled with the environmental impact, which leads to the failure of electrical contacts. For optical fiber communication, bit error rate (BER) seriously affects information exchange.
A rf coaxial connectors, includes casing, casing has touched on a setting hole, touch a set fixed inside the plug with a touch, touch of an electric conductor, involving an electric conductor of the internal thread consists of insulators and conductors fixed according to the electric conductor of electric conductor, touch a front-end developer to compatible with touch a plug, touch a backend development of fixed set is composed of laminated glass produced in conjunction with an electric conductor block cavity glass sealed components, wear consists of contact any electrical conductor in glass sealed components, transportation within the inner end of the electric conductor and electrical conductor, the toe of the switching of electric conductor used to connect with the power supply circuit. This product to touch a backend development has produced in conjunction with an electric conductor block cavity glass sealed components, sealing glass sealed set of component will contact any electrical conductor in electric conductor connected to the power circuit,, interior of an electric conductor is produced to block cavity, keep the good magnetic shielding materials and gas tightness, reasonable avoid touching a transfer in data signal from external interference signal.
Follow the official website
More wonderful waiting for you!
Company address：12 Runshou Road, Binjiang Development Zone, Jiangning District, Nanjing